Men’s Hiking Shoes (WATERPROOF) MH100 - Khaki

We have classified our product in terms of performance and function to suit the 3 levels of Mountain Walking: - Occasional: a dozen hikes a year for approximately 3 to 4 hours, under 10 km and under 700m of vertical distance. - Regular: twenty outings a year. 4 to 6 hours, 10 to 20 km, 700 to 1200m of vertical distance per outing. - Intensive: for over 20 outings per year. For over 6 hours, over 20 km, 1200 to 2000m of vertical distance per outing.

For the fabric on the cuff lining and on the inner sole coating of these boots, we dye the thread during manufacturing to reduce the environmental impact. Textile dyeing requires a lot of water but also produces waste water from the dye baths. To reduce this environmental impact, we use a mass pigmentation process that involves adding the colour pigments when the yarn itself is produced.

The grip of our soles is certified. To be awarded it, the shoes must pass laboratory tests to assess the grip rate on different surfaces (Smooth, Rugged, Dry, Wet). To validate these tests, we assess the quality of our soles in the field, the mountains, by a panel of representative testers over 500 km.

In a laboratory, the boot is immersed in water to mid-height on a mechanical arm that flexes to simulates a number of steps. With this test we can determine a time and number of km that the boot can walk while staying dry. Then we confirm in the field or under the rain, that the shoe meets its promises.

To keep your feet dry, we advise you to use a waterproof gaiter or mini-gaiter to protect the top of your boots and prevent water, pebbles and sand from getting in. We advise re-waterproofing your boots twice a year using a re-waterproofing agent (search for ‘waterproofing’ on our Decathlon website) which will help you restore the original water-repellent qualities and help prevent stains on the outside.

The most important thing is to try on several sizes and styles of boots to find the one most suited to you! You can take a size above your usual one to prevent the toes from bumping into the toe box when going downhill, provided the foot is properly supported to avoid friction. Tip: keep your toenails short and, before a long descent, check that your lacing is tight enough to prevent your foot from sliding forwards inside the boot.

Some Decathlon stores have a test route. 1. Try on both shoes, standing up, with the socks worn for hiking. 2. Tighten the laces, taking care to correctly balance the tightening. 3. Check two points: - the heel does not come up before the boot when you walk uphill. - the foot does not slide and the toes do not press against the front when going downhill. 4. Try on several sizes and models. Break them in gradually to adapt them to your foot.

A waterproof boot will be less breathable than a non-waterproof boot. Socks like the MH500, MH520 and MH900 with a high or medium upper (adapted to the height of the boot) are therefore preferable for wicking away perspiration and reducing friction.

The original insole in your boots is designed to accommodate most feet. A change of insole can bring: 1. Improved support: some soles are preformed or reinforced to better support the arch of the foot. 2. More comfort: the insoles can also provide heat and/or cushioning. 3. Longer life: restore the support and comfort of your shoes by replacing the insole each season.

- Leave to air-dry. - Remove dry mud with a stiff brush. - For stains, clean with a brush and a little warm water - Leave to dry - Spray with a re-waterproofing agent to restore the water-repellent properties of the upper.