Non-slip adhesive pads for snowboard boards

    8344833

    DREAMSCAPE

    From

    ₹ 599.00

    Non-slip adhesive pads for snowboard boards

    Made for The pads have been developed to prevent the foot from sliding on the snowboard, when taking a chairlift for example. These non-slip, adhesive pads can be stuck quickly and will not move thanks to the 3M glue. Your foot grips well without slipping on the board thanks to the 12 points of rubber type.

    Advantage
    TractionStructures with 12 points: maximum grip of the shoe on the pad.
    Grip3M Scotch tape for a very good bond between the pad and the board.
    GripNon-slip material so that the boot does not slip on the pad.
    Anatomic designStick the 4 pads where you want to adapt to your sole.
    Technical Information
    1
    Advice on gluing the pad to the board
    It is important that you take 4 minutes to stick the pad down properly. 1. Before gluing, clean the board well with a damp sponge and soap or dish soap to degrease it. 2. Rinse thoroughly to remove any soap. 3. Dry with a cloth. 4. Stick the pads where you want them, near the rear binding.
    2
    Choice of the position of the pads
    Place the 4 pads where you will put your foot when you take the chairlift. Before gluing, think about simulating a chairlift ride to find the area where your back foot is to be positioned.Caution! Do not glue the pads within 4 cm of the screw inserts, otherwise you will no longer benefit from the maximum setting of the bindings.
    Information / Concept / Technology
    Stockage tips
    Patch: 100.0% Polyvinyl Chloride
    Show results for
    DECATHLON , is present in more than 26 countries